This is the Redbird Speed Stage 3 package for the early A-Body General Motors vehicles from 1964-1972. This includes the Chevelle, GTO, El Camino, Olds 442, Cutlass, and Monte Carlo. This 9" housing and axle package, back brace, center section, 14" 6 piston front brake kit and 14" 6 piston rear kit would be a great for a serious build that demands stopping power. This would be good for some street and strip. The gear driven posi will take more abuse than a spring and clutch style unit. The brakes are going to give you great stopping power. The 14" rotors will require a 20" rim.  Contact us to see if it is a good fit for your application. 

 

Moser Housing and Axle Package:

  • 35 spline axles, 1541H, access holes, 1 piece bearing, 1/2" studs
  • All of our housing use 3" OD tube stock with 1/4" thick walls. Housing has a raw finish
  • Back brace, fill and drain included
  • This is designed to work with stock suspension

 

Center Section:

  • Moser Aluminum case
  • 35 spline Wavetrac gear driven posi unit
  • Daytona support
  • 1350 yoke
  • US Gear
  • Gear and posi are setup in the case

 

Baer 6 piston brake kits with 14" Rotors

 

| Why Purchase the Pro+?

  • Baer’s best-selling system featuring the 6-Piston (6P) caliper
  • 2-piece rotor design with a 6061 T-6 billet aluminum hat bolted to the rotor friction ring with high grade NAS (Aircraft) hardware. Rotors comes pre-assembled
  • Includes a set of 6061-T6 billet machined hubs pre-assembled with studs and premium bearings packed with Redline synthetic grease  
  • Standard colors are Red, Black or Silver (Custom colors and finishes also available)

The 6P Pro+ Caliper Features:

  • 6-piston, 2-piece caliper with six, 3/8” cross bolts for added strength
  • Stainless steel pistons, abutments and noise suppression springs
  • Staggered piston sizes to minimize pad wear
  • Dual seals (dust/weather and pressure)
  • Uses the C5 and C6 backing plate (1997-2013 Corvette) or the FMSI #D731
  • Caliper can accept 13” and 14” rotors
  • Red, Black or Silver Powder Coat Finish (custom colors available)
  • Machined logo that is hand painted
  • Uses correct banjo style fittings, Baer does not use any pipe thread
  • 100% MADE IN USA with US sourced material

 

This housing will be shipped out in its raw finish. You will need to paint it. This ships in 5 boxes by ground. Parts will need to be bolted together. Gear/Posi are setup in the case.

 

Free shipping applies to continental US 48 states only. 

 

Sales tax only