Looking for a complete rear end for your A-body Chevelle using stock suspension? Want it fully assembled? Reach out to us if you have questions about this complete rear end for a A Body.
Rear shown with raw steel finish, but optional semi gloss black powder coat is available as an upgrade.
1964-1967 A-Body Stamped Heavy Duty Housing and Axle Package
- Stock width wheel mounting surface to wheel mounting surface 60" wheel to wheel
- Stamped style 9" Ford can
- Ears, control arm brackets, spring cups welded on housing
- Fill hole, drain plug
- Rubber bushings in ears
- 3" tubes / 1/4" wall - seamless DOM
- 31 spline Moser Engineering bolt-in style axles
- 1541H American Made Axles
- Sealed ball bearings
- 5 x 4 3/4" bolt pattern
- 1/2-20 Studs - 2" Long Screw in Style
- Access hole in axle face
- Torino ends, common 2 1/2" brake offset, 2.771" hub
- Wilwood disc brakes installed
- Choice of 11" or 12" Rotors, Drilled and slotted
- Choice of red or black calipers
Center Section:
- Yukon Iron Case
- Helical Gear Driven Posi
- Aluminum Daytona Pinion Support
- 1350 Yoke
- Choice of Gear Ratio
- Gear/Posi are Setup in the Center Section
Need hoses and cables? Click here for optional hoses and parking brake cables.
Housing takes standard 9" center section. Axle bearings are common Ford 88128 found at any part store. 2.500" OD / 1.500" ID Inner Housing End Seals included.
If you would like to narrow this rear, use a different bolt pattern, use different studs, use another gear ratio, use a spool, or hold the shipment at your local terminal we can accommodate your needs. Reach out to us and we will get you a custom quote.
You can expect an estimated 3 week build time depending on shop workload, powder coat or custom options. Contact us if you need a rear faster.
Ships assembled by truck freight.
Sales tax only applies to Indiana residents.
Any questions, leave a note or contact us a 260-301-2424.