top of page

12-Bolt 1997-2004 Corvette (C5) Rear Sub Frame Kit!


Moser Engineering C-5 Corvette Rear Sub Frame Kit!

Fits: 1997-2004 Chevrolet Corvette
*Kit ships within 3 weeks of online order completion!
The standard kit includes the following;
New Moser 12-Bolt Housing
35 Spline Custom Alloy Axles
Moser Lightweight Steel Spool
12-Bolt Pro/Comp Ring & Pinion
1350 Series Chrome Moly Pinion Yoke
Timken Bearings
5/8" Drive Stud Kit (2" or 3")
Sealed Axle Bearings
Chrome Moly - Torque Arm, Driveshaft Loop, Transmission Cross-member, Panhard Bar, Track Locator, Lower Control Arms, Spring Saddles, Anti-Roll Adjuster, Anti-Roll Arm, Anti-Roll Tubes and Frame Rails
Mild Steel - Front Cross-member, Rear Cross-member, Upper Shock Mounts, Spring Mounts
All Associated Hardware is supplied!


The Moser Engineering rear sub frame kit in the C-5 Corvettes. This kit was primarily designed for NHRA Stock Eliminator classes but can be adapted for other uses. Since the C-5 Corvette is designed to be an independent rear with a transaxle, modifications must be made to the transmission tunnel, torque tube tunnel and upper rear control arm mounts to facilitate this installation. These modifications must be done in advance of the installation of this kit. The lower portion of the rear frame rails directly above the rear end housing may need to be C notched for adequate clearance. The stock fuel tanks, lines, etc.... need to be removed as well.

1997-2004 Corvette (C5) Rear Sub Frame Kit, 12 Bolt

    bottom of page