Want to supply your own brakes? We use a Torino/Late Ford, 2 1/2" brake offset, 2.771" Hub, 5.850" Flange OD, and an Access hole. This opens you up to almost any manufacturer of disc brakes. We have many to to offer from factory style kits to Wilwood. Contact us for a custom quote.
This Moser Engineering package comes with housing, axles, and center section.
9" Stamped Heavy Duty Rear End Package - Bare (No Brackets)
- Custom wheel mounting surface to wheel mounting surface
- Stamped heavy duty housing
- 3" tubes / 1/4" wall - seamless DOM
- 31 spline Moser Engineering bolt-in style axles
- Nodular iron case
- Truetrac posi
- Choice of gear ratio
- 1350 yoke
- Sealed ball bearings
- Choice of bolt pattern
- Torino ends, common 2 1/2" brake offset, 2.771" hub, and access holes
- Rear shown with optional fill/drain, not included
Housing take a 9" center and uses a 3.062 Nodular Iron case. Axle bearings are common Ford 88128 found at any part store.
Pinion Offset:
- Center Pinion - Driveshaft Centered
- 1/2" Offset - Stock for Camaro, Nova, S10, Chevy Trucks
- 15/16" Offset - Centered Can, Equal Tube Lengths typically used when welding ears on top of the can
We recommend Lucas 80/90 non-synthetic with no additives in Truetrac differentials.
If you would like to have this rear assembled, narrow this rear, use a different bolt pattern, switch to housing ends, hold the shipment at your local terminal, we can accommodate your needs. Reach out to us and we will get you a custom quote.
You can expect a 2 day build time and ships in 4 boxes by UPS Ground.
Sales tax only applies to Indiana residents.
Any questions, leave a note or contact us a 260-301-2424.