This Moser Engineering package comes with housing, axles, center section, and 11" Wilwood kit 140-11389. 
 
9" Stamped Heavy Duty Rear End Package - Bare (No Brackets)
Custom wheel mounting surface to wheel mounting surface
Stamped heavy duty housing
3" tubes / 1/4" wall - seamless DOM
31 spline Moser Engineering bolt-in style axles
Nodular iron case
Truetrac posi
Choice of gear ratio
1350 yoke
Sealed ball bearings
Choice of bolt pattern 
Torino ends, common 2 1/2" brake offset, 2.771" hub, and access holes
140-11389 Wilwood Kit, 11" Rotors, Internal Parking Brake 
Rear shown with optional fill/drain, not included 
 
Housing take a 9" center and uses a 3.062 Nodular Iron case. Axle bearings are common Ford 88128 found at any part store. 
 
Pinion Offset:
Center Pinion - Driveshaft Centered
1/2" Offset - Stock for Camaro, Nova, S10, Chevy Trucks
15/16" Offset - Centered Can, Equal Tube Lengths typically used when welding ears on top of the can
 
We recommend Lucas 80/90 non-synthetic with no additives in Truetrac differentials. 
 
If you would like to have this rear assembled, narrow this rear, use a different bolt pattern, switch to housing ends, hold the shipment at your local terminal, we can accommodate your needs. Reach out to us and we will get you a custom quote. 
 
You can expect a 2 day build time and ships in 4 boxes by UPS Ground. 
 
Sales tax only applies to Indiana residents. 
 
Any questions, leave a note or contact us a 260-301-2424.