This Moser Engineering package comes with housing, axles, center section and brakes. 
 
9" Stamped Heavy Duty Rear End Package - Bare (No Brackets)
Custom wheel mounting surface to wheel mounting surface
Stamped heavy duty housing
3" tubes / 1/4" wall - seamless DOM
31 spline Moser Engineering bolt-in style axles
Nodular case
Truetrac posi
Choice of gear ratio
1350 yoke
Sealed ball bearings
Choice of bolt pattern 
Torino ends, common 2 1/2" brake offset, 2.771" hub, and access holes
Economy disc brakes, 11" single piston, parking brake
Rear shown with optional fill/drain, not included 
 
Housing take a 9" center and uses a 3.062 Nodular Iron case. Axle bearings are common Ford 88128 found at any part store. 
 
Want to supply your own brakes? We use a Torino/Late Ford, 2 1/2" brake offset, 2.771" Hub, 5.850" Flange OD, and an Access hole. This opens you up to almost any manufacturer of disc brakes. We have many to to offer from factory style kits to Wilwood. Contact us for a custom quote.  
 
Pinion Offset:
Center Pinion - Driveshaft Centered
1/2" Offset - Stock for Camaro, Nova, S10, Chevy Trucks
15/16" Offset - Centered Can, Equal Tube Lengths typically used when welding ears on top of the can
 
We recommend Lucas 80/90 non-synthetic with no additives in Truetrac differentials. 
 
If you would like to have this rear assembled, narrow this rear, use a different bolt pattern, switch to other brakes, hold the shipment at your local terminal, we can accommodate your needs. Reach out to us and we will get you a custom quote. 
 
You can expect a 2 day build time and ships in 4 boxes by UPS Ground. 
 
Sales tax only applies to Indiana residents. 
 
Any questions, leave a note or contact us a 260-301-2424.