Looking for a complete rear end for your G-body using stock suspension? Want it fully assembled? Reach out to us if you have questions about this complete rear end for an G-Body.
Rear shown with optional semi gloss black powder coat. This is available as an upgrade in the options. Otherwise, rear is made in the raw finish.
1978-1987 G-Body Stamped Heavy Duty Housing and Axle Package
- Stock width wheel mounting surface to wheel mounting surface
- Stamped style 9" Ford can
- Ears, control arm brackets, spring cups welded on housing
- Fill hole, drain plug
- Rubber bushings in ears
- 3" tubes / 1/4" wall - seamless DOM
- 31 spline QP bolt-in style axles
- 1541H American Made Axles
- Sealed ball bearings
- 5 x 4 3/4" bolt pattern
- Studs Installed
- Access hole in axle face
- Torino ends, common 2 1/2" brake offset, 2.771" hub
- 11" Drum Brakes Installed
Center Section:
- Yukon Iron Case
- Helical Gear Driven Posi
- Aluminum Daytona Pinion Support
- 1350 Yoke
- Choice of Gear Ratio
- Gear/Posi are Setup in the Center Section
Housing takes standard 9" center section. Axle bearings are common Ford 88128 found at any part store. 2.500" OD / 1.500" ID Inner Housing End Seals included.
If you would like to narrow this rear, use a different bolt pattern, use different studs, use another gear ratio, use a spool, or hold the shipment at your local terminal we can accommodate your needs. Reach out to us and we will get you a custom quote.
You can expect an estimated 3 week build time depending on shop workload, powder coat or custom options. Contact us if you need a rear faster.
Ships assembled by truck freight.
Sales tax only applies to Indiana residents.
Any questions, leave a note or contact us a 260-301-2424.