top of page

1994-2004 SN95 Mustang Fully Assembled Complete Moser Engineering Rear End

  • Stock width or custom
  • Upper and lower control arm mounts are welded on the housing
  • Moser Engineering Fabricated 9" Ford housing
  • Bare Finish (Shown with optional powder coat)
  • 3" tubes / 1/4" wall - seamless DOM
  • 35 spline Moser Engineering bolt-in style axles
  • 33/35/40 spline axles have a 10-year warranty
  • Wavetrac posi
  • Choice of gear ratio
  • 1350 yoke
  • Sealed ball bearings
  • 5 x 4 1/2 Mustang bolt pattern 
  • Torino ends, common 2 1/2" brake offset, 2.780" hub, and access holes
  • Wilwood brakes 11 or 12", drilled and slotted, choice of black or red calipers (requires 16" or larger rims)


Housing take a 9" center and uses a 3.250" Moser nodular iron case. Axle bearings are common Ford 88128 found at any part store. 


We recommend Motul 300 75-90 synthetic with no additives in Wavetrac differentials. 


If you would like to narrow this rear, powdercoat the housing, use a different bolt pattern, switch to other brakes, hold the shipment at your local terminal, we can accommodate your needs. Reach out to us and we will get you a custom quote. 


You can expect a 5-7 day build time. Powdercoating adds about 1 week to production. 


Sales tax only applies to Indiana residents. 


Any questions, leave a note or contact us a 260-301-2424. 



Fully Assembled, 1994-2004 Mustang, Fabricated 9", 35 Spline Wavetrac, Moser

Caliper Color
    bottom of page